HP ProLiant ML350 Generation 4p User Manual

76 HP ProLiant ML350 Generation 4p Server User Guide
Installing the Rack Server
To install the rack server:
1. Install the server into a rack ("Installing the Server into the Rack" on page
37
).
2. Connect the power cord and peripheral devices. Refer to Rear Panel
Components (on page 12
) for connector locations.
3. Power up the server ("Powering Up the Server" on page 25
).
4. Install the operating system ("Installing the Operating System" on page 44
).
5. Register the server. To register a server, refer to the registration card in the
HP ProLiant Essentials Foundation Pack or the HP Registration website
(http://register.hp.com
).
Accessing the Server in the Rack
To perform some installation or maintenance procedures, the server must be
extended from the rack ("Extending the Server from the Rack" on page 26
).
If the maintenance procedure requires accessing the server rear panel:
1. Unlock the cable management arm and swing the arm away from the server.

HP ProLiant ML350 Generation 4p Specifications

General

Processor Socket	Socket 604
Chipset	Intel E7520
Form Factor	Tower
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server
Processor	Intel Xeon
Memory	PC2-3200 DDR2 SDRAM
Memory Slots	8
Storage	SAS or SATA (depending on configuration)
Drive Bays	Up to 8 hot-plug drive bays
Network	Embedded NC7782 PCI-X Gigabit Server Adapter
Power Supply	Redundant power supply optional
Expansion Slots	6 total: 2 PCI-Express, 2 PCI-X