HP ProLiant ML350 Generation 4p User Manual

Hardware Options Installation 73
Tower-to-Rack Conversion Option
Converting a Tower Server to a Rack Server (on page 73)
Installing the Rack Server (on page 76
)
Accessing the Server in the Rack (on page 76
)
Converting a Tower Server to a Rack Server
The tower-to-rack conversion kit includes all equipment required to convert the
tower model server into a rack model server, and to install the server into most
square- or round-hole racks.
The tower-to-rack conversion kit includes:
•
•
•
•
•
•
•
•
•
Rack rails
Cable management arm
Server rails
Cage nuts
Rack template
Server bezel for rack environment
In addition to the supplied items, you may need:
T-10 Torx screwdriver
T-15 Torx screwdriver
Pencil
To convert a tower server to a rack server:
1. Power down the server ("Powering Down the Server" on page 25
).
2. Remove the front bezel door, if necessary ("Removing the Front Bezel
(Tower Model)" on page 27
).

HP ProLiant ML350 Generation 4p Specifications

General

Processor Socket	Socket 604
Chipset	Intel E7520
Form Factor	Tower
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server
Processor	Intel Xeon
Memory	PC2-3200 DDR2 SDRAM
Memory Slots	8
Storage	SAS or SATA (depending on configuration)
Drive Bays	Up to 8 hot-plug drive bays
Network	Embedded NC7782 PCI-X Gigabit Server Adapter
Power Supply	Redundant power supply optional
Expansion Slots	6 total: 2 PCI-Express, 2 PCI-X