HP ProLiant ML350 Generation 4p User Manual

Hardware Options Installation 63
IMPORTANT: HP recommends installing the tape drive on a separate
SCSI cable to avoid a decrease in performance on other SCSI devices.
8. Connect the data and power cables to the back of the device.
9. Connect the data cable into a SCSI controller channel (secondary SCSI
channel shown).
10. Replace the front bezel ("Removing the Front Bezel (Tower Model)" on page
27
), if applicable.
11. Replace the access panel ("Removing Access Panel" on page 27
).
Installing an Internal Two-Bay Hot-Plug SCSI Drive Cage Option
You can install up to two half-height or one full-height removable media device
in the removable media cage. To install a half-height or full-height media device:
1. Extend the server from the rack, if applicable ("Extending the Server from
the Rack" on page 26
).
2. Remove the front bezel door, if necessary ("Removing the Front Bezel
(Tower Model)" on page 27
).
3. Remove the access panel ("Removing Access Panel" on page 27
).
4. Access the removable media cage ("Accessing the Removable Media Cage"
on page 58
).

HP ProLiant ML350 Generation 4p Specifications

General

Processor Socket	Socket 604
Chipset	Intel E7520
Form Factor	Tower
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server
Processor	Intel Xeon
Memory	PC2-3200 DDR2 SDRAM
Memory Slots	8
Storage	SAS or SATA (depending on configuration)
Drive Bays	Up to 8 hot-plug drive bays
Network	Embedded NC7782 PCI-X Gigabit Server Adapter
Power Supply	Redundant power supply optional
Expansion Slots	6 total: 2 PCI-Express, 2 PCI-X