HP ProLiant ML350 Generation 4p User Manual

60 HP ProLiant ML350 Generation 4p Server User Guide
1. Loosen the thumbscrew securing the shipping bracket to the server.
2. Remove the shipping bracket.
3. Before shipping the server with an option installed in the removable media
bay, reverse steps 1 and 2 to install the shipping brackets.
Installing a Half-Height or Full-Height Media Device Option
The server includes four removable media bays. The lower two bays are
occupied with a 3.5-inch diskette drive and an IDE CD-ROM drive. The upper
two removable media bays are vacant. You can install up to two half-height or
one full-height removable media devices in the removable media cage. To install
a half-height or full-height media device:
1. Power down the server ("Powering Down the Server" on page 25
).
2. Extend the server from the rack, if applicable ("Extending the Server from
the Rack" on page 26
).
3. Remove the front bezel door, if necessary ("Removing the Front Bezel
(Tower Model)" on page 27
).
4. Remove the access panel ("Removing Access Panel" on page 27
).
5. Remove the media device blanks.

HP ProLiant ML350 Generation 4p Specifications

General

Processor Socket	Socket 604
Chipset	Intel E7520
Form Factor	Tower
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server
Processor	Intel Xeon
Memory	PC2-3200 DDR2 SDRAM
Memory Slots	8
Storage	SAS or SATA (depending on configuration)
Drive Bays	Up to 8 hot-plug drive bays
Network	Embedded NC7782 PCI-X Gigabit Server Adapter
Power Supply	Redundant power supply optional
Expansion Slots	6 total: 2 PCI-Express, 2 PCI-X