HP ProLiant ML350 Generation 4p User Manual

Hardware Options Installation 75
a. Use the T-10 Torx screwdriver to remove the two front panel screws.
Slide tower configuration panel back and then away from the chassis.
7. Align the pins on the server bezel with the corresponding slots on the chassis
and push down. Secure the server bezel to the chassis by tightening the
thumbscrews.
8. Replace the access panel ("Removing Access Panel" on page 27
).

HP ProLiant ML350 Generation 4p Specifications

General

Processor Socket	Socket 604
Chipset	Intel E7520
Form Factor	Tower
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server
Processor	Intel Xeon
Memory	PC2-3200 DDR2 SDRAM
Memory Slots	8
Storage	SAS or SATA (depending on configuration)
Drive Bays	Up to 8 hot-plug drive bays
Network	Embedded NC7782 PCI-X Gigabit Server Adapter
Power Supply	Redundant power supply optional
Expansion Slots	6 total: 2 PCI-Express, 2 PCI-X