HP ProLiant ML350 Generation 4p User Manual

66 HP ProLiant ML350 Generation 4p Server User Guide
WARNING: To reduce the risk of injury from electric
shock hazards, do not open power supplies. Refer all maintenance,
upgrades, and servicing to qualified personnel.
CAUTION: Electrostatic discharge (ESD) can damage
electronic components. Be sure that you are properly grounded
(earthed) before beginning any installation procedure.
NOTE: Do not attempt to remove the power supply from a non-hot-plug
SCSI model.
IMPORTANT: The HP ProLiant ML350 Generation 4 and ProLiant
ML350 Generation 4p server power supplies are not interchangeable.
To install the optional hot-plug redundant power supply:
1. Identify the redundant power supply bay at the back of the server.
IMPORTANT: Power supplies for the model shown are hot-pluggable.
When using the redundant power supply option, it is not necessary to
power down the server before removing or installing a power supply.
2. Loosen thumbscrews and remove the power supply blank.
WARNING: To reduce the risk of electric shock or damage
to the equipment, do not connect AC power cords to uninstalled
power supplies.

HP ProLiant ML350 Generation 4p Specifications

General

Processor Socket	Socket 604
Chipset	Intel E7520
Form Factor	Tower
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server
Processor	Intel Xeon
Memory	PC2-3200 DDR2 SDRAM
Memory Slots	8
Storage	SAS or SATA (depending on configuration)
Drive Bays	Up to 8 hot-plug drive bays
Network	Embedded NC7782 PCI-X Gigabit Server Adapter
Power Supply	Redundant power supply optional
Expansion Slots	6 total: 2 PCI-Express, 2 PCI-X