HP ProLiant ML350 Generation 4p - Page 88

88 HP ProLiant ML350 Generation 4p Server User Guide
If hard drives and the SCSI or SmartArray controller are not already installed,
follow the steps in the sections "Installing Hard Drives ("Installing Hot-Plug
SCSI Hard Drives" on page 55
)" and "Installing an Expansion Board (on page
68
)".
To cable a Smart Array or other RAID controller:
1. Locate and remove the SCSI cable from the SCSI primary connector on the
system board.
2. Reconnect the SCSI cable to either the SCSI controller option or SmartArray
Controller.