HP UPS - Reconfiguring the Agent on HP-UX Operating Systems; Uninstalling Components from Windows Systems

Installing the HP UPS Power Protection Agent 40
• Change any items that should be unique, such as the Management Server IP address, through the
normal operation of the software.
To install the agent on a system running HP-UX using the silent installation method:
1. Create a temporary directory.
2. Copy the following files into the temporary directory you just created:
o DevManRA.ini—During an assisted install, this file is landed in the same folder in which the
agent is installed.
o EULA—This file is included with the installation files on the HP Infrastructure Management Pack
CD and the software download package on the HP website
(http://www.hp.com/go/rackandpower
).
o SetupRA—This file is included with the installation files on the HP Infrastructure Management
Pack CD and the software download package on the HP website
(http://www.hp.com/go/rackandpower
).
o Uninstall—This file is included with the installation files on the HP Infrastructure Management
Pack CD and the software download package on the HP website
(http://www.hp.com/go/rackandpower
).
o HPRA4.5Buildx.depot—This file is included with the installation files on the HP Infrastructure
Management Pack CD and the software download package on the HP website
(http://www.hp.com/go/rackandpower
).
3. From the directory that contains all five files, run ./SetupRA -s -f DevManRA.ini to install
silently.
If the .ini file is not located in the same folder as the SetuprRA file, run ./SetupRA -s -f
<path> DevManRA.ini, where <path> is the DevManRA.ini file location.
The following command line parameters can be specified and are applicable for both interactive and
silent modes.
Parameter Function
-s
Specifies a silent install.
-l
Creates an installation log
(opt/DevMan/install.log). Default is disabled for
interactive mode and enabled for silent mode.
The installation log is created automatically for
Windows® during silent installations in
\%systemdrive%\setup.log.
-f DevManRA.ini
Specifies a configuration .ini file used for clean
installs. When this option is specified, the device
detection and configuration step is omitted.
Reconfiguring the agent on HP-UX operating systems
To reconfigure the management module IP address or serial path, run /sbin/init.d/DevMan setup.
Uninstalling components from Windows® systems
1. Click Start>Settings>Control Panel.