HP UPS Management Module web interface 69
SNMP Traps tab
This screen enables administrators to configure SNMP trap event notifications.
To configure the SNMP trap notifications:
1. Enable SNMP traps for up to 10 servers.
2. Enter the IP address for up to 10 trap recipients in the IP Address field.
3. Enter the community string for each trap recipient.
4. Do one of the following:
o Click Save Settings to save the information.
o Click Undo Changes to undo the changes.
o Click Help to view online help.
5. Click Send Test Trap to send a test SNMP trap.
Attached Devices menu
Click Attached Devices in the left navigation frame to display the Attached Devices screen. This screen
enables administrators to manage attached devices.
NOTE: Depending on the specific UPS model, this screen will vary.
To Next Page
Loading...
Need help?
General
