Overview 8
HP UPS Power Protection Agent overview
The HP UPS Power Protection Agent runs on a local or network server and allows the management
module to gracefully shut down the operating system of that server and optionally run a script during
power failure. Install the agent on any machine that is powered by the UPS and any machine that the
management module uses to initiate a command.
NOTE: If you are an existing HP Power Manager user, you must uninstall the HPPM Remote
Agent before installing the UPS Power Protection Agent.
If the UPS Power Protection Agent is not applicable for your load devices, you can use a third-party
SNMP manager to monitor the power protection. For more information, see "SNMP monitoring (on page
116)."
HP UPS Power Protection Agent requirements
NOTE: For the latest supported operating systems, see the HP website
(http://www.hp.com/go/rackandpower
).
Hardware and software Suggested minimum requirements
Hardware 200-MHz processor
Disk space 10 MB free disk space
System memory 64 MB of RAM
Operating system (32-bit)
Microsoft® Windows Server® 2008 R1 Standard, Enterprise, and Datacenter
Editions
Microsoft® Windows Server® 2003 R2 Standard and Enterprise Editions
Microsoft® Windows Server® 2003 R1 Standard and Enterprise Editions
Microsoft® Windows® Small Business Server 2003, Standard and Premium
Editions x86 R2 with Service Pack 2
Microsoft® Windows Server® 2003 Standard and Enterprise Editions x86 R2
with Service Pack 1
Microsoft® Windows® 7 Enterprise
Microsoft® Windows® XP Professional with Service Pack 3
Microsoft® Windows® Vista Professional with Service Pack 2
Red Hat Enterprise Linux 5 for x86 with Update 3
SUSE Linux Enterprise Server 11 for x86
SUSE Linux Enterprise Server 10 for x86 with Service Pack 3
VMware ESX Server 3.5.5 U5¹
VMware ESX Server 4.0 U1¹
VMware ESX Server 3.5.0¹
To Next Page
Loading...
Need help?
General
