HP V1905 Series - Configuring Queue Algorithm

65
Table 82 CoS Setup Page item description
Item Descri
p
tion
QoS Mode
Specifies if QoS is enabled on the switch. The possible values are:
 Disabled: Restores the switch factory defaults for QoS values and disables
configure QoS values on the switch.
 Enabled: Enables configure QoS values on the switch.
Set Default
Sets the default user priority. The possible field values are 0-7, where 0 is the lowest
and 7 is the highest priority.
Restore Default Restores the switch factory defaults for CoS values.
Viewing CoS Settings
The CoS Summary Page displays CoS default settings assigned to ports.
Click Device  QoS  CoS. The CoS Summary Page opens.
Figure 103 CoS Summary Page
The CoS Summary Page contains the following fields:
Table 83 CoS Summary Page item description
Item Descri
p
tion
Port Displays the interface for which the CoS default value is defined.
Default CoS
Displays the default CoS value for incoming packets for which a VLAN priority tag is
not defined.
Configuring Queue Algorithm
The Queue Setup Page contains the queue algorithm information.
Click Device  QoS  Queue. The Queue Setup Page opens.