Removing a hard disk drive from the optical drive bay
1.
Disconnect power from the workstation (see
Predisassembly procedures on page 77).
2.
Remove the side access panel (see
Removing the side access panel on page 79).
3.
Remove the airflow guide (see
Removing the airflow guide on page 80).
4.
Remove the expansion card support (see
Removing the expansion card support on page 82).
5.
Disconnect the power and data cables from the rear of the hard drive as shown in the following
figure.
Figure 5-59 Removing the power and data cables
132 Chapter 5 Replacing components ENWW
To Next Page
Loading...
