15
Menus Tasks
Static Routing
• Display IPv4 and IPv6 static route entries.
• Create, modify, and delete IPv4 and IPv6 static route entries.
Policy-Based Routing
• Create, modify, and delete IPv4 and IPv6 policies.
• Configure interface PBR.
• Configure local PBR.
Multicast
IGMP Snooping
• Configure IGMP snooping functions, including:
{ Enable dropping unknown multicast data.
{ Configure the IGMP snooping querier.
{ Enable fast-leave processing.
{ Set the maximum number of multicast groups on a port.
MLD Snooping
• Configure MLD snooping functions, including:
{ Enable dropping unknown IPv6 multicast data.
{ Configure the MLD snooping querier.
{ Enable fast-leave processing.
{ Set the maximum number of IPv6 multicast groups on a port.
Service
DHCP
• Configure DHCP server functions, including:
{ Configure DHCP services.
{ Configure the interface to operate in the DHCP server mode.
{ Configure DHCP address pools.
{ Configure the IP address conflict detection.
• Configure DHCP relay agent functions, including:
{ Configure DHCP services.
{ Configure the DHCP relay agent mode
{ Configure the IP address of the DHCP server
• Configure settings for DHCP relay entry, include:
{ Recording of DHCP relay entries.
{ Periodic refreshing of DHCP relay entries.
{ Interval for refreshing DHCP relay entries.
HTTP/HTTPS
• Enable or disable HTTP service.
• Enable or disable HTTPS service.
• Set the Web connection idle timeout.
• Set the HTTP service port number.
• Set the HTTPS service port number.
• Specify Web access control ACLs.
SSH (not available in
Release 3111P02)
• Enable the Stelnet, SFTP, and SCP services.
• Set the DSCP in packets sent by the device.
• Filter SSH clients by using an ACL.
• Set the SFTP connection idle timeout time.
FTP
• Enable or disable FTP service.
• Set the DSCP value for the device to use for outgoing FTP packets.
• Specify the FTP access control ACL.
• Set the FTP connection idle timeout.
To Next Page
Loading...
