Operations 27
2.
Align the hole in the access panel latch with the guide pin on the chassis.
3. Close the access panel latch. The access panel slides to a closed position.
4. Use a T-15 Torx screwdriver to tighten the access panel latch screw.
Remove the SPI board
To remove the component:
1. Power down the server (on page 24).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Extend the server from the rack (on page 25).
4. Remove the access panel (on page 26).
5. Remove the processor memory drawer shipping screws, if installed. Retain the screws for future use
("Processor memory drawer shipping screw locations" on page 30).
6. Extend the processor memory drawer approximately 2.54 to 5.1 cm (1 to 2 inches).
To Next Page
Loading...
