Hardware options installation 85
7.
Install the expansion board.
8. Close the expansion slot retainer.
9. Connect any required internal or external cables to the expansion board.
10. Install the access panel (on page 26).
11. Install the server in the rack ("Installing the server into the rack" on page 38).
12. Connect each power cord to the server.
13. Connect each power cord to the power source.
14. Power up the server ("Powering up the server" on page 24).
FBWC module and capacitor pack option
CAUTION: The cache module connector does not use the industry-standard DDR3
mini-DIMMs. Do not use the controller with cache modules designed for other controller
models, because the controller can malfunction and you can lose data. Also, do not transfer
this cache module to an unsupported controller model, because you can lose data.
To install the component:
1. Back up all data.
2. Close all applications.
3. Power down the server (on page 24).
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
CAUTION: In systems that use external data storage, be sure that the server is the first unit
to be powered down and the last to be powered back up. Taking this precaution ensures that
the system does not erroneously mark the drives as failed when the server is powered up.
5. Extend the server from the rack (on page 25).
6. Remove the access panel (on page 26).
7. Remove the SPI board (on page 27).
To Next Page
Loading...
