Hardware options installation 58
11.
While holding the baffle door open, install the new memory cartridge.
12. Install the processor memory drawer cover ("Remove the processor memory drawer cover" on page
32).
13. Install the processor memory drawer ("Remove the processor memory drawer cover" on page 32, on
page 31).
14. Connect each power cord to the server.
15. Connect each power cord to the power source.
16. Power up the server ("Powering up the server" on page 24).
SAS drive backplane option
CAUTION: To prevent damage to electrical components, take the appropriate anti-static
precautions before beginning any system installation. Improper grounding can cause
electrostatic discharge.
To install the component:
1. Power down the server (on page 24).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Remove the access panel (on page 26).
To Next Page
Loading...
