Operations 28
7.
Loosen the thumbscrews on the SPI board, and then lift the SPI board to access the cables.
8. Disconnect all cables from the SPI board.
IMPORTANT: If replacing the SPI board or clearing NVRAM, you must re-enter the server
serial number through the Advanced System ROM options in UEFI System Utilities
("Re-entering the server serial number and product ID" on page 101).
9. Remove the SPI board from the server.
Install the SPI board
CAUTION: To prevent damage to electrical components, take the appropriate anti-static
precautions before beginning any system installation. Improper grounding can cause
electrostatic discharge.
To install the component:
1. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
2. Do one of the following:
o Extend the server from the rack (on page 25).
o Remove the server from the rack (on page 24).
3. Remove the access panel (on page 26).
4. Remove the processor memory drawer shipping screws, if installed. Retain the screws for future use
("Processor memory drawer shipping screw locations" on page 30).
To Next Page
Loading...
