HPE ProLiant DL580 Gen9 - Troubleshooting and Diagnostics; Troubleshooting Resources and Guides

Hardware options installation 71
7.
Install the access panel (on page 26).
8. Connect each power cord to the server.
9. Connect each power cord to the power source.
10. Power up the server ("Powering up the server" on page 24).
Power adapter cables option
WARNING: Do not install these cables in servers that do not specifically identify them in the
server documentation. Improper installation of these cables results in damage to the servers
and connecting cards and voids the warranty.
To install the component:
1. Power down the server (on page 24).
2. Remove all power:
a. Disconnect the power cord from the power source.
b. Disconnect the power cord from the server.
3. Remove the server from the rack (on page 24).
4. Remove the access panel (on page 26).
5. Locate the I/O board auxiliary power connectors.
Item Description
1
I/O board auxiliary power connector
2
I/O board auxiliary power connector
3
I/O board auxiliary power connector
4
I/O board auxiliary power connector
5
I/O board auxiliary power connector
6
I/O board auxiliary power connector
IMPORTANT: The PCIe slots provide 75W of power. The remaining wattage is supplied by
the power cable to obtain the total wattage required.