Operations 31
Remove the processor memory drawer
WARNING: The processor memory drawer weighs more than 11.3 kg (25.0 lb). Use extra
caution when removing and replacing the processor memory drawer.
1. Remove the processor memory drawer shipping screws, if installed. Retain the screws for future use
("Processor memory drawer shipping screw locations" on page 30).
2. Push the button on the release lever.
3. Lower the handle, and then extend the processor memory drawer from the server until the release
latches catch.
4. Firmly holding the processor memory drawer, press the release buttons, and then remove the
drawer from the server.
Install the processor memory drawer
CAUTION: To prevent damage to electrical components, take the appropriate anti-static
precautions before beginning any system installation. Improper grounding can cause
electrostatic discharge.
To install the component:
1. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
2. Do one of the following:
o Extend the server from the rack (on page 25).
o Remove the server from the rack (on page 24).
3. Remove the access panel (on page 26).
To Next Page
Loading...
