Operations 33
CAUTION: To prevent damage to electrical components, take the appropriate anti-static
precautions before beginning any system installation. Improper grounding can cause
electrostatic discharge.
To install the component:
1. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
2. Do one of the following:
o Extend the server from the rack (on page 25).
o Remove the server from the rack (on page 24).
3. Remove the access panel (on page 26).
4. Remove the processor memory drawer (on page 31).
5. Install the processor memory drawer cover.
6. Install the processor memory drawer ("Remove the processor memory drawer cover" on page 32, on
page 31).
7. Install the access panel (on page 26).
8. Install the server into the rack ("Installing the server into the rack" on page 38).
9. Connect each power cord to the server.
10. Connect each power cord to the power source.
11. Power up the server ("Powering up the server" on page 24).
Access the Systems Insight Display
To access the Systems Insight Display:
1. Press and release the panel.
To Next Page
Loading...
