Hardware options installation 89
7.
Install the TPM security rivet by pressing the rivet firmly into the system board.
8. Install the SPI board (on page 28).
9. Install the access panel.
10. Slide the server into the rack.
11. Power up the server ("Powering up the server" on page 24).
Enabling the Trusted Platform Module
1. During the server startup sequence, press the F9 key to access System Utilities.
2. From the System Utilities screen, select System Configuration > BIOS/Platform Configuration
(RBSU) > Server Security.
3. Select Trusted Platform Module Options and press the Enter key.
4. Select Enabled to enable the TPM and BIOS secure startup. The TPM is fully functional in this
mode.
5. Press the F10 key to save your selection.
6. When prompted to save the change in System Utilities, press the Y key.
7. Press the ESC key to exit System Utilities. Then, press the Enter key when prompted to reboot the
server.
The server then reboots a second time without user input. During this reboot, the TPM setting becomes
effective.
You can now enable TPM functionality in the OS, such as Microsoft Windows BitLocker or measured
boot.
CAUTION: When a TPM is installed and enabled o
n the server, data access is locked if you
fail to follow the proper procedures for updating the system or option firmware, replacing the
system board, replacing a hard drive, or modifying OS application TPM settings.
For more information on firmware updates and hardware procedures, see the HP Trusted Platform
Module Best Practices White Paper on the Hewlett Packard Enterprise Support Center website
(http://www.hpe.com/support/hpesc).
For more information on adjusting TPM usage in BitLocker, see the Microsoft website
(http://technet.microsoft.com/en-us/library/cc732774.aspx).
To Next Page
Loading...
