HPE ProLiant e910 - Page 80

• System Programmable Logic Device (CPLD)
• Backplane
• Innovation Engine (IE)
• Server Platform Services (SPS)
• Language Packs
Some firmware types are delivered as a combined update. For example:
• A SAS Programmable Logic Device update is often combined with a SAS controller firmware update.
• The Intelligent Platform Abstraction Data firmware is often combined with a System ROM/BIOS update.
Requirements for firmware update to take eect
Depending on the firmware type, additional action might be required for the update to take eect.
• iLO firmware or language pack—These firmware types take eect after an automatically triggered iLO reset.
• System ROM (BIOS)—Requires a server reboot.
• Chassis firmware (Power Management) and Edgeline Chassis Controller Firmware—Take eect immediately.
• System Programmable Logic Device (CPLD)—Requires a server reboot.
• Power Management Controller and NVMe Backplane Firmware—Do not require a server reboot or a system reset.
The NVMe firmware version will be displayed in the iLO web interface after the next server reboot.
• Innovation Engine (IE) and Server Platform Services (SPS)—These firmware types require that you power o the server
before installation. The changes take eect after you power on the server.
Obtaining the iLO firmware image file
You can download the iLO firmware image file and use it to update a single server or multiple servers in a group.
The BIN file from the iLO Online ROM Flash Component is required for updating the iLO firmware with the Flash Firmware or
Group Firmware Update features.
Procedure
1.
Navigate to the following website:
http://www.hpe.com/support/hpesc.
2. To locate and download the iLO Online ROM Flash Component file, follow the onscreen instructions.
Download a Windows or Linux component.
3. Extract the BIN file.
• For Windows components: Double-click the downloaded file, and then click the Extract button. Select a location for the
extracted files, and then click OK.
• For Linux components: Depending on the file format, enter one of the following commands:
◦ #./<firmware_file_name>.scexe –unpack=/tmp/
◦ #rpm2cpio <firmware_file_name>.rpm | cpio -id
80 Using HPE iLO 5