HPE ProLiant ML30

◦ Extend the server from the rack.
◦ Remove the server from the rack.
4. Remove the front bezel.
5. Remove the access panel.
6. Remove the air baffle:
a. Remove the front end of the baffle from the chassis.
b. Remove the baffle from the slots on the rear chassis.
Removing and replacing the front bezel
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
• If the server is in tower mode: Place the server on its side with the access panel facing up.
• If the server is in rack mode, do one of the following:
◦ Extend the server from the rack.
◦ Remove the server from the rack.
5. Remove the front bezel:
34 Removal and replacement procedures