To replace the component, reverse the removal procedure.
Removing and replacing an SFF hot-plug drive
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all
bays are populated with either a component or a blank.
Procedure
1. Back up all server data on the drive.
2. Remove the front bezel.
3. Determine the status of the drive from the drive LED definitions.
4. Remove the drive.
To replace the component, reverse the removal procedure.
Removing and replacing media devices
Removing and replacing a SAS LTO tape drive
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
1. Power down the server.
2. Remove all power:
40 Removal and replacement procedures
To Next Page
Loading...
