CAUTION: Be sure to close the processor socket retaining bracket before closing the
processor locking lever. The lever must close without resistance. Forcing the lever closed can
damage the processor and socket, requiring system board replacement.
CAUTION: Do not press down on the processor. Pressing down on the processor might
damage the processor socket and the system board. Press only in the area indicated on the
processor retaining bracket.
CAUTION: To avoid damage to the processor, do not touch the bottom of the processor,
especially the contact area.
2. Clean the old thermal grease from the heatsink with the alcohol swab. Allow the alcohol to evaporate
before continuing.
3. Apply all the grease to the top of the processor in the following pattern to ensure even distribution.
4. Install the heatsink.
5. If removed, install the air baffle.
6. Install the front bezel.
7. Install the access panel.
8. Connect all peripheral cables to the server.
9. Connect each power cord to the server.
10. Connect each power cord to the power source.
11. Power up the server.
Removing and replacing the standard power supply
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the power supply and the
power supply blank to cool before touching them.
Removal and replacement procedures 67
To Next Page
Loading...
