9. Disconnect any internal cables that are connected to the expansion board.
10. Remove the expansion board.
To replace the component, reverse the removal procedure.
Removing and replacing a Smart Array storage controller
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all
PCI slots have either an expansion slot cover or an expansion board installed.
CAUTION: Before replacing a DIMM, expansion board, or other similar PCA components due to a
perceived hardware error, make sure first that the component is firmly seated in the slot. Do not
bend or flex circuit boards when reseating components.
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Removal and replacement procedures 55
To Next Page
Loading...
