• Press the Power On/Standby button.
• Use the virtual power button through iLO.
Extending the server from the rack
NOTE: PCI fan is required while the server is in rack mode.
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
WARNING: To reduce the risk of personal injury or equipment damage, be sure that the rack is
adequately stabilized before extending a component from the rack.
4. Slide the server tray out of the rack:
a. Loosen the server tray thumbscrews.
b. Grasp the tray notch and slide the server out of the rack.
Removal and replacement procedures 29
To Next Page
Loading...
