Hsun HS700UTV - Checking the Coolant Level; Changing the Coolant

3-16
4. Install:
·air filter element
·air filter case cover
Note :
To prevent air leaks make sure that the sealing
surface of the element matches the sealing surface
of the case.
console
·passenger seat
·driver seat
CHECKING THE COOLANT LEVEL
1. Place the vehicle on a level surface.
2. Lift the hood up.
3. Check:
·Start the engine, warm it up for several minutes, and
then turn it off.
·coolant level
Note:
Before checking the coolant level, wait a few
minutes until the coolant has settled.
·coolant level
The coolant level should be between the minimum
level mark ○A and maximum level mark ○b.Below the
minimum level mark → Add the recommended coolant
to the proper level.
CHANGING THE COOLANT
1. Remove:
·driver seat
·passenger seat
·console
Lift the hood up.。
·coolant reservoir cap ①
·Disconnect coolant reservoir hose ②
·Adding water instead of coolant lowers the antifreeze
content of the coolant. If water is used instead o
f
coolant, check and if necessary, correct the antifreeze
concentration of the coolant.
·Use only distilled water. However, soft water may be