Hsun HS700UTV - Checking the Coolant Temperature Warning Light

To Next Page

To Previous Page

3-19

Note：

dding water instead of coolant lowers the

antifreeze content of the coolant. If water is used

instead of coolant, check, and if necessary, correct

the antifreeze concentration of the coolant. Use only

distilled water. However, soft water may be used i

distilled water is not available.

14. Install:

·air bleed bolt

9 Nm (0.9 m · kg, 6.5 ft · lb)

·radiator cap

·Fill coolant reservoir:

(with the recommended coolant to the maximum level

mark○a)

·Install coolant reservoir cap:

·Start the engine, warm it up for several minutes, and

then turn it off.

·Check:

coolant level

Refer to “THE COOLANT” in chapter 4.

Note:

Before checking the coolant level, wait a few minutes

until the coolant has settled.

·Close the hood.

·Install console:

·Install passenger seat

·Install driver seat

Refer to “SEATS,” in chapter 5.

CHECKING THE COOLANT TEMPERATURE

WARNING LIGHT

Coolant temperature indicator light①