3-26
d. Place the other end of the hose into a container.
e. Slowly apply the brake pedal several times.
f. Push down on the pedal and hold it.
g. Loosen the bleed screw and allow the pedal to travel
towards its limit.
h. Tighten the bleed screw when the pedal limit has been
reached, then release the pedal.
i. Repeat steps (e) to (h) until all the air bubbles have
disappeared from the fluid.
. Tighten the bleed screw.
Front brake caliper bleed screw
6 Nm (0.6 m · kg, 4.3 ft · lb)
Rear brake caliper bleed screw
5 Nm (0.5 m · kg, 3.6 ft · lb)
Note:
If bleeding is difficult, it may be necessary to let the
brake fluid settle for a few hours.
Repeat the bleeding procedure when the tiny
bubbles in the system have disappeared.
k. Add brake fluid to the proper level.
WARNING:
Check the operation of the brake after bleeding the
brake system.
ADJUSTING THE SELECT LEVER SHIFT ROD
Neutral①
High②
③ Low
④ Reverse
⑤ Select lever shift rod
WARNING:
Before shifting, you must stop the vehicle and take
your foot off the accelerator pedal.
Otherwise, the transmission may be damaged.
1. Adjust:
·Select lever shift rod
a. Make sure the select lever is in NEUTRAL.
To Next Page
Loading...