continuity.
。
Note:
Set the tester to the “Ω × 1” position.
b. If the tester indicates“∞”, replace the fuse.
3. Replace:
• blown fuse
a. Turn off the ignition.
b. Install a new fuse of the proper amperage.
c. Turn on switches to verify operation of the related
electrical devices.
d. If the fuse immediately blows again, check the
electrical circuit.
Description
Current
rating
Quantity
Main 30 A 1
Lighting
system fuse
15 A 1
Ignition 10 A 1
Terminal
(Auxiliary
DC jack)
10 A 1
4WD(Four wheel
drive)
3 A 1
Signaling
system fuse
10 A 1
Carburetor
heater fuse
10 A 1
Backup fuse 10 A 1
Reserve 30 A 1
Reserve 15 A 1
Reserve 10 A 1
Reserve 3 A 1
WARNING:
Never use a fuse with a rating other than that
specified. Never use other materials in place of a
fuse. An improper fuse may cause extensive
To Next Page
Loading...