Huawei AR150 series - Associating an ACL with an Address Pool; Configuring Easy IP

To Next Page

To Previous Page

The public address pool IDs are numerals. Up to 8 address pools can be configured.

By default, no public address pool is configured on the AR150/200.

----End

5.3.3 Associating an ACL with an Address Pool

Network administrators can use ACLs to control which users can access public networks using

NAT.

Procedure

Step 1 Run:

system-view

The system view is displayed.

Step 2 Run:

interface interface-type interface-number

The interface view is displayed.

Step 3 Run:

nat outbound acl-number [ address-group group-index [ no-pat ] | interface

loopback interface-number ]

An ACL is associated with an address pool.

After an ACL is associated with an address pool, the AR150/200 translates source addresses of

data packets matching the ACL to an IP address in the address pool. Different IP address

translation entries can be configured on an interface.

In the command, no-pat indicates one-to-one NAT, that is, only the IP address is translated and

the port number is not translated

----End

5.3.4 Configuring Easy IP

Easy IP uses an interface IP address as the source address of data packets matching an ACL.