Huawei AR150 series - Configuration Examples; Example for Configuring Primary and Secondary IP Addresses for an Interface

Time exceed: 0
IP header bad: 0
Timestamp request: 0
Timestamp reply: 0
Information request: 0
Information reply: 0
Netmask request: 0
Netmask reply: 0
Unknown type: 0
2.5 Configuration Examples
This section provides several IP address configuration examples.
2.5.1 Example for Configuring Primary and Secondary IP Addresses
for an Interface
Networking Requirements
As shown in Figure 2-1, Ethernet0/0/0 on the Router is connected to a LAN. On the LAN, two
hosts belong to network segment 172.16.1.0/24 and another two hosts belong to network segment
172.16.2.0/24. The Router is required to access the two network segments.
Figure 2-1 Network diagram for configuring IP addresses
172.16.1.0/24
172.16.2.0/24
Router
Ethernet 0/0/0
172.16.1.1/24
172.16.2.1/24 sub
Configuration Roadmap
The configuration roadmap is as follows:
1. Plan IP addresses for interfaces.
2. Configure the primary and secondary IP addresses for an interface.
Data Preparation
To complete the configuration, you need the following data:
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - IP Service 2 IP Address Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
45