Huawei AR150 series - 2 Product Installation

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
arp static ip-address mac-address vid vlan-id interface interface-type interface-
number
A static ARP entry is configured in a VLAN.
When configuring a static ARP entry in a VLAN, you must specify the outbound interface so
that the packets are sent out from the specified outbound interface.
----End
1.3.4 Configuring a Static ARP Entry in a VPN Instance
To implement Layer 2 communication between devices in a VPN instance, you can configure
static ARP entries in the VPN instance.
Context
NOTE
To configure static ARP entries for double-tagged packets, run the arp static cevid command.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
arp static ip-address mac-address vpn-instance vpn-instance-name
A static ARP entry is configured for a VPN instance.
----End
1.3.5 Checking the Configuration
Procedure
l Run the display arp [ all ] command to check all ARP entries, including static ARP entries
and dynamic ARP entries.
l Run the display arp network net-number net-mask [ dynamic | static ] command to check
ARP entries on the specified network segment.
l Run the display arp static command to check static ARP entries.
l Run the display arp statistics { all | interface interface-type interface-number } command
to check statistics on ARP entries on the AR150/200 or the specified interface.
----End
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - IP Service 1 ARP Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6