Huawei AR150 series - Enabling the DHCP;BOOTP Client

On the AR150/200, a Layer 3 Ethernet interface or its sub-interface, a Layer 3 Eth-
trunk interface or its sub-interface, or a VE interface can be configured to function as
a DHCP client.
4. Run:
ip address dhcp client hostname hostname
A host name is configured for the DHCP client.
5. Run:
ip address dhcp client option61 client-name
An identifier is configured for the DHCP client.
6. Run:
ip address dhcp client request-option { dhcp-file-name | dns-domain | ftp-
user-ip | ftp-user-name | ftp-user-password | route | tftp-server-ip |
tftp-server-name }
*
The list of options attributes is configured for the DHCP client.
l Configure BOOTP client attributes.
1. Run:
system-view
The system view is displayed.
2. Run:
dhcp enable
The DHCP service is enabled.
3. Run:
interface interface-type interface-number
The interface view is displayed.
On the AR150/200, a Layer 3 Ethernet interface or its sub-interface, a Layer 3 Eth-
trunk interface or its sub-interface, or a VE interface can be configured to function as
a BOOTP client.
4. Run:
ip address bootp client hostname hostname
A host name is configured for the BOOTP client.
----End
6.6.3 Enabling the DHCP/BOOTP Client
After the DHCP/BOOTP client function is enabled on an interface, the interface can obtain an
IP address and other configurations from the DHCP server.
Procedure
l Enable the DHCP client.
1. Run:
system-view
The system view is displayed.
2. Run:
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - IP Service 6 DHCP Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
151