Huawei AR150 series - Checking the Configuration

Return to the system view.
To configure UCMP on other interfaces, repeat steps 2 through 7.
NOTE
Traffic is load balanced based on bandwidth only when UCMP is enabled on outbound interfaces of all the
equal-cost links and FIB entry updating is triggered. If UCMP is not enabled on any outbound interface,
the equal-cost links evenly load balance traffic even though FIB entry updating is triggered.
----End
7.4.3 Checking the Configuration
After setting the load balancing mode for IP packet forwarding, you can view the load balancing
configuration.
Procedure
l Run the display fib [ slot-id ] command to check the FIB table on a specified LPU.
l Run the display fib acl acl-number [ verbose ] command to check FIB entries matching
an ACL.
l Run the display fib [ slot-id ] destination-address1 [ destination-mask1 ] [ longer ]
[ verbose ] command to check FIB entries matching destination addresses.
l Run the display fib [ slot-id ] destination-address1 destination-mask1 destination-
address2 destination-mask2 [ verbose ] command to check FIB entries matching
destination addresses in the range of destination-address1 destination-mask1 to
destination-address2 destination-mask2.
l Run the display fib ip-prefix prefix-name [ verbose ] command to check FIB entries
matching the specified IP prefix list.
l Run the display fib interface interface-type interface-number command to check FIB
entries matching a specified interface.
l Run the display fib next-hop ip-address command to check FIB entries matching a
specified next hop address.
l Run the display fib [ slot-id ] statistics command to check the total number of FIB entries.
----End
Example
# Run the display fib command to view the summary of the FIB table.
<Huawei> display fib
Route Flags: G - Gateway Route, H - Host Route, U - Up Route
S - Static Route, D - Dynamic Route, B - Black Hole Route
------------------------------------------------------------------------------
FIB Table:
Total number of Routes : 4
Destination/Mask Nexthop Flag TimeStamp Interface TunnelID
127.0.0.1/32 127.0.0.1 HU t[49] InLoop0 0x0
127.0.0.0/8 127.0.0.1 U t[49] InLoop0 0x0
127.255.255.255/32 127.0.0.1 HU t[49] InLoop0 0x0
255.255.255.255/32 127.0.0.1 HU t[49] InLoop0 0x0
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - IP Service 7 IP Performance Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
183