Huawei AR150 series - Configuration Examples; Example for Disabling the Sending of ICMP Redirection Packets

To Next Page

To Previous Page

l Run the display fib ip-prefix prefix-name [ verbose ] command in any view to check FIB

entries matching the specified IP prefix list.

l Run the display fib interface interface-type interface-number command in any view to

check FIB entries matching a specified interface.

l Run the display fib next-hop ip-address command in any view to check FIB entries

matching a specified next hop address.

l Run the display fib [ slot-id ] statistics command in any view to check the total number

of FIB entries.

l Run the display fib [ slot-id ] command in any view to check information about the FIB

table.

l Run the display ip socket [ monitor ] [ task-id task-id socket-id socket-id | sock-type

socket-type ] command in any view to check the IP socket information.

----End

7.7 Configuration Examples

This section provides IP performance configuration examples.

7.7.1 Example for Disabling the Sending of ICMP Redirection

Packets

Networking Requirements

As shown in Figure 7-1, to limit the sending of ICMP redirection packets, RouterA, RouterB,

and RouterC are required to be connected with each other by using layer 3 interfaces.

Figure 7-1 Network diagram of Disabling the Sending of ICMP Redirection Packets

Internet

RouterA

RouterC

Eth1/0/0

1.1.1.1/24

1.1.1.2/24

Eth1/0/0Eth1/0/0

2.2.2.2/24

RouterB

Huawei AR150&200 Series Enterprise Routers

Configuration Guide - IP Service 7 IP Performance Configuration

Issue 02 (2012-03-30) Huawei Proprietary and Confidential

189

Other manuals for Huawei AR150 series