Huawei AR150 series - Setting the Interval for Advertising RA Messages; Configuring the Address Prefixes to be Advertised

Step 3 Run:
(Optional)undo ipv6 nd ra halt
The function of advertising RA messages is enabled.
----End
3.4.4 Setting the Interval for Advertising RA Messages
The device periodically sends router advertisement messages containing information such as
prefixes and flag bits.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
ipv6 nd ra { max-interval maximum-interval | min-interval minimum-interval }
The interval for advertising RA messages is configured.
By default, the maximum interval is 600 seconds and the minimum interval is 200 seconds.
The maximum interval can not be shorter than the minimum interval.
When the maximum interval is less than 9 seconds, the minimum interval is set to the same value
as the maximum interval.
----End
3.4.5 Configuring the Address Prefixes to Be Advertised
Nodes of the local links can perform address auto-configuration by using prefixes of these
addresses.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
ipv6 nd ra prefix { ipv6-address ipv6-prefix-length | ipv6-prefix/ipv6-prefix-
length } valid-lifetime preferred-lifetime [ no-autoconfig ] [ off-link ]
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - IP Service 3 Basic IPv6 Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
62