Huawei AR150 series - Checking the Configuration

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
ipv6 nd ra preference { high | medium | low }
The default router priority is configured in RA packets.
Step 4 Run:
ipv6 nd ra route-information ipv6-address prefix-length lifetime route-lifetime
[ preference { high | medium | low } ]
Route information is configured in RA packets.
----End
3.4.8 Checking the Configuration
You can view the configuration of IPv6 neighbor discovery.
Prerequisites
The configurations of the IPv6 neighbor discovery function are complete.
Procedure
l Run the display ipv6 neighbors [ ipv6-address | [ vid vlan-id ] interface-type interface-
number | vpn-instance vpn-instance-name ]display ipv6 neighbors interface-type
interface-number| [vid vid ] | [cevid cevid] command to check the neighbor information in
the cache.
l Run the display ipv6 interface [ interface-type interface-number | brief ] command to
check the IPv6 information of an interface. If the interface is in the Up state, the
configuration is successful.
----End
Example
Run the display ipv6 neighbors command. If the cache of the neighbor information contains
neighbors' IPv6 addresses and the specified interfaces, it means that the configuration succeeds.
<Huawei> display ipv6 neighbors ethernet 1/0/0
--------------------------------------------------------
IPv6 Address : 3003::2
Link-layer : 00e0-fc89-fe6e State : STALE
Interface : Eth1/0/0 Age : 7
VLAN : 10 CEVLAN: -
VPN name : vpn1 Is Router: TRUE
Secure FLAG : UN-SECURE
IPv6 Address : FE80::2E0:FCFF:FE89:FE6E
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - IP Service 3 Basic IPv6 Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
65