Huawei AR150 series - Checking the Configuration

Step 2 Run:
dhcp server ping packet number
The maximum number of ping packets that the AR150/200 can send to the same destination is
configured.
The default value is 0. The AR150/200 sends no ping packet and does not perform a ping.
Step 3 Run:
dhcp server ping timeout milliseconds
The timeout period to wait for a response packet is set for the AR150/200.
By default, the timeout period is 500 milliseconds.
----End
6.3.9 Checking the Configuration
This section describes how to check the configurations of the DHCP server based on the global
address pool.
Prerequisites
The configurations of the DHCP server based on the global address pool are complete.
Procedure
l Run the display dhcp server statistics command to check the statistics on the DHCP
server.
l Run the display ip pool name ip-pool-name [ low-ip-address high-ip-address | all |
expired | conflict | used ] command to check information about the configured global
address pool.
----End
Example
Run the display dhcp server statistics command to view statistics on the DHCP server.
<Huawei> display dhcp server statistics
DHCP Server Statistics:
Client Request: 6
Dhcp Discover: 1
Dhcp Request: 4
Dhcp Decline: 0
Dhcp Release: 1
Dhcp Inform: 0
Server Reply: 4
Dhcp Offer: 1
Dhcp Ack: 3
Dhcp Nak: 0
Bad Messages: 0
Run the display ip pool name ip-pool-name command to view information about the IP address
pool named pool1.
<Huawei> display ip pool name pool1
Pool-Name : pool1
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - IP Service 6 DHCP Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
136