Huawei AR150 series - Example for Configuring Layer 2 Topology Detection

<Router> display arp
IP ADDRESS MAC ADDRESS EXPIRE(M) TYPE INTERFACE VPN-INSTANCE
VLAN/CEVLAN
------------------------------------------------------------------------------
10.10.10.1 0018-2000-0083 I - Vlanif4
10.10.10.2 00e0-fc00-0002 19 D-0 Ethernet0/0/0
2/-
10.10.10.3 00e0-fc00-0003 19 D-0 Ethernet0/0/1
2/-
10.10.10.4 00e0-fc00-0004 19 D-0 Ethernet0/0/2
3/-
10.10.10.5 00e0-fc00-0005 19 D-0 Ethernet0/0/3
3/-
------------------------------------------------------------------------------
Total:5 Dynamic:4 Static:0 Interface:1
----End
Example
The following lists only the configuration file of the Router.
#
sysname Router
#
vlan batch 2 to 4
#
vlan 4
aggregate-vlan
access-vlan 2 to 3
#
interface Vlanif4
ip address 10.10.10.1 255.255.255.0
arp-proxy inter-sub-vlan-proxy enable
#
interface ethernet 0/0/0
port link-type access
port default vlan 2
#
interface ethernet 0/0/1
port link-type access
port default vlan 2
#
interface ethernet 0/0/2
port link-type access
port default vlan 3
#
interface ethernet 0/0/3
port link-type access
port default vlan 3
#
return
1.11.5 Example for Configuring Layer 2 Topology Detection
Networking Requirements
As shown in Figure 1-5, two Ethernet interfaces are added to VLAN 100 in default mode. To
view changes of ARP entries, configure Layer 2 topology detection.
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - IP Service 1 ARP Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
34