Huawei AR150 series - Checking the Configuration

dhcp enable
The DHCP service is enabled.
3. Run:
interface interface-type interface-number
The interface view is displayed.
On the AR150/200, a Layer 3 Ethernet interface or its sub-interface, a Layer 3 Eth-
trunk interface or its sub-interface, or a VE interface can be configured to function as
a DHCP client.
4. Run:
ip address dhcp-alloc
The DHCP client function is enabled on the AR150/200.
l Enable the BOOTP client.
1. Run:
system-view
The system view is displayed.
2. Run:
dhcp enable
The DHCP service is enabled.
3. Run:
interface interface-type interface-number
The interface view is displayed.
On the AR150/200, a Layer 3 Ethernet interface or its sub-interface, a Layer 3 Eth-
trunk interface or its sub-interface, or a VE interface can be configured to function as
a BOOTP client.
4. Run:
ip address bootp-alloc
The BOOTP client function is enabled on the AR150/200.
----End
6.6.4 Checking the Configuration
This section describes how to check the configurations of the DHCP/BOOTP client.
Prerequisites
The DHCP/BOOTP client configurations are complete.
Procedure
l Run the display current-configuration command to check the configurations of the
DHCP/BOOTP client.
----End
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - IP Service 6 DHCP Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
152