Huawei AR150 series - Enabling Intra-VLAN Proxy ARP; Checking the Configuration

Step 3 Run:
control-vid vid dot1q-termination
The control VLAN and encapsulation mode of the sub-interface are configured.
Step 4 Run:
dot1q termination vid vid
The single VLAN ID for dot1q encapsulation on a sub-interface is configured.
----End
1.6.4 Enabling Intra-VLAN Proxy ARP
Intra-VLAN proxy ARP implements Layer 3 communication between isolated users in a VLAN.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface { ethernet | eth-trunk } interface-number.sub-interface-number
The sub-interface view is displayed.
Or, run:
interface vlanif vlan-id
The VLANIF interface view is displayed.
Step 3 Run:
arp-proxy inner-sub-vlan-proxy enable
Intra-VLAN proxy ARP is enabled.
By default, intra-VLAN proxy ARP is disabled.
----End
1.6.5 Checking the Configuration
After configuring intra-VLAN proxy ARP, you can view the intra-VLAN proxy ARP
configuration.
Procedure
l Run the display arp interface interface-type interface-number [ vid vlan-id [ cevid cevlan-
id ] ] command to check ARP entries on the specified interface.
l Run the display arp vpn-instance vpn-instance-name [ dynamic | static ] command to
check ARP entries in the specified VPN instance.
l Run the display arp dynamic command to check dynamic ARP entries.
l Run the display arp statistics { all | interface interface-type interface-number } command
to check statistics on ARP entries on the AR150/200 or the specified interface.
----End
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - IP Service 1 ARP Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
15