Huawei AR150 series - Example for Configuring Ipv6 Neighbor Discovery

FF02::1:FF9B:6D3B
MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 1
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
# On Router A, ping the global unicast IPv6 address of Router B.
[RouterA] ping ipv6 3001::2
PING 3001::2 : 56 data bytes, press CTRL_C to break
Reply from 3001::2
bytes=56 Sequence=1 hop limit=64 time = 2 ms
Reply from 3001::2
bytes=56 Sequence=2 hop limit=64 time = 2 ms
Reply from 3001::2
bytes=56 Sequence=3 hop limit=64 time = 2 ms
Reply from 3001::2
bytes=56 Sequence=4 hop limit=64 time = 2 ms
Reply from 3001::2
bytes=56 Sequence=5 hop limit=64 time = 2 ms
--- 3001::2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 2/2/2 ms
----End
Configuration Files
l Configuration file of Router A
#
sysname RouterA
#
ipv6
#
interface ethernet1/0/0
ipv6 enable
ipv6 address 3001::1/64
#
return
l Configuration file of Router B
#
sysname RouterB
#
ipv6
#
interface ethernet1/0/0
ipv6 enable
ipv6 address 3001::2/64
#
return
3.9.2 Example for Configuring IPv6 Neighbor Discovery
This section describes how to configure IPv6 neighbor discovery.
Networking Requirements
As shown in Figure 3-2, two routers are connected through GE interfaces. Configure IPv6 link-
local address for the GE interfaces and enable the routers to send RA messages.
Huawei AR150&200 Series Enterprise Routers
Configuration Guide - IP Service 3 Basic IPv6 Configuration
Issue 02 (2012-03-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
78