Huawei FusionModule500 Smart - Installing Power Supply and Distribution Devices; Installing Lithium Batteries

Figure 4-12 Drainpipe routed from the bottom
NO TICE
● After routing the water pipe, secure it to the pipe assembly using cable ties,
and seal the cable hole using
restop putty.
● After connecting the drainpipe, check whether the drainage is normal.
Step 4 Install the bae plate for the smart cooling product.
----End
Follow-up Procedure
Before removing the smart cooling product, remove the upper bae plate and the
side panels on both sides of the cabinet.
4.2.5 Installing Power Supply and Distribution Devices
4.2.5.1 Installing Lithium Batteries
Context
Install lithium batteries in the 11th U and higher positions of the cabinet.
Procedure
Step 1 Push a lithium battery into the cabinet and secure it.
FusionModule500 Smart Mini Data Center
User Manual (Philippines, FusionModule500-
SU61A12S) 4 Installation Guide
Issue 02 (2021-06-30) Copyright © Huawei Technologies Co., Ltd. 68