Huawei FusionServer G5500 - Page 127

21 In the displayed dialog box, select Enabled and press Enter.
NOTE
To disable a network port, select Disabled and press Enter.
Set the BIOS password.
22 Select Security and press Enter.
The Security screen is displayed, as shown in Figure 5-42.
Figure 5-42 Security
23 Select Set Supervisor Password and press Enter, and set the administrator password.
The current password of the system administrator is required before you change the
password. The system will be locked if an incorrect password is entered three
consecutive times. You can unlock the system by restarting it.
NOTE
The administrator password must meet the following requirements:
– The password must be a string of 8 to 16 characters and contain special characters (including
spaces) and at least two types of the following characters: uppercase letters, lowercase letters,
and digits.
– The previous five passwords cannot be reused as a new password.
– After the password is set, the following parameters are displayed:
n
Clear Supervisor Password: clears the administrator password.
n
Power on Password: sets the power-on password.
n
Set All Hdd Password: sets all the hard disk passwords.
n
Set All Master Hdd Password: sets all the master hard disk passwords.
FusionServer G5500 Server
User Guide
5 Configuring the G5500
Issue 02 (2017-12-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
119