Figure 8-58 Removing a PCIe riser module
Step 6 Disconnect the cable between the PCIe card and the NC-SI port.
For details, see 7.4 PCIe Card Cabling.
This operation is required only when the PCIe card is an SP380 NIC (BOM code: 02312JBD).
Step 7 Remove the PCIe card.
For details, see 8.4.19 Removing a PCIe Card.
Step 8 Place the removed PCIe riser module and PCIe card in
dierent ESD bags.
Place only one component in an ESD bag.
Step 9 Install a ller panel.
Perform this operation only when a PCIe riser module is not installed immediately.
FusionServer Pro XH321 V5 Server Node
Maintenance and Service Guide 8 Parts Replacement
Issue 17 (2021-03-09) Copyright © Huawei Technologies Co., Ltd. 91
To Next Page
Loading...
