Step 4 Use restop putty to seal the cable holes at the bottom.
Step 5 Install the removed cover.
----End
5.4 Installing AC Input Power Cables
Prerequisites
● The ESS is not powered on.
● AC input power cables have been pre-buried.
● The OT/DT terminals of the AC input power cables have been crimped. For
details, see B Crimping an OT or DT Terminal.
Procedure
Step 1 Remove the protective cover.
Figure 5-8 Removing the protective cover
Step 2 Remove the bae plates for the AC input power cables.
LUNA2000-2.0MWH-1H0, 2H0 Smart String ESS
User Manual 5 Installing Cables
Issue 02 (2021-11-15) Copyright © Huawei Technologies Co., Ltd. 94
To Next Page
Loading...