Huawei LUNA2000-2.0MWH-1H0 - Check Alarms

Figure 8-13 Third-party device
9. Complete the conguration.
Figure 8-14 Completing the conguration
----End
8.3 Check Alarms
Step 1 Log in to the SmartLogger WebUI and check whether an alarm is generated. If no
alarm is generated, proceed with the power-on operations. If an alarm is
generated, clear the alarm by referring to the handling suggestions.
Step 2 Short-circuit the water sensor and check whether a water alarm is generated on
the SmartLogger WebUI:
● If a water alarm is generated, the water sensor is properly connected. In this
case, the water alarm will be cleared after the short circuit is removed.
● If no water alarm is generated, check whether the water sensor cable is
properly connected.
LUNA2000-2.0MWH-1H0, 2H0 Smart String ESS
User Manual 8 SmartLogger Web-based Deployment
Issue 02 (2021-11-15) Copyright © Huawei Technologies Co., Ltd. 126