Figure 8-11 Connecting cables
● When securing the network cable (as shown by ⑥ in the gure), hold the cable and
align it with the FE network port. After the network cable is properly installed, do not
release it. Use the other hand to tighten the nut of the RJ45 connector.
● After the network cable is installed, gently pull it down to check that it is properly
installed.
Step 4 Install the maintenance compartment cover and decorative cover to the rack
controller, and place the magnetic rings.
Figure 8-12 Installing covers
Step 5 Install the protective covers delivered with the product, connect a ground cable to
the protective cover on the left or right side, and bind the cable.
LUNA2000-(97KWH-1H1, 129KWH-2H1,
161KWH-2H1, 200KWH-2H1) Smart String ESS
User Manual 8 Installing Cables
Issue 10 (2023-11-07) Copyright © Huawei Digital Power Technologies Co., Ltd. 117
To Next Page
Loading...